Garmin GPS 400W, Installation Manual

Page: 208 / 212

Page H-52 GNS 400W Series Installation Manual
Rev. G 190-00356-08
P1001
GTN 6XX/7XX
GNS 400W SERIES
P4001
GPS RS232 OUT 3
GPS RS232 IN 3
41
42
25 RS-232 IN 3
RS-232 OUT 3 6
44 RS-232 GND 3/4
s
5
GNS 400W Series – GTN 6XX/7XX Crossfill
1. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE SPECIFIED.
2. GROUND DESIGNATIONS: SHIELD BLOCK GROUND AIRFRAME GROUND
3. AT THE GNS 400W, CONNECT SHIELD GROUNDS TO THE CONNECTOR BACKSHELL -- THE SHIELD LEADS
MUST BE LESS THAN 3.0". CONNECT OTHER SHIELD GROUNDS TO AIRCRAFT GROUND WITH AS SHORT A
CONDUCTOR AS PRACTICAL.
4. REFERENCE SECTION 5 FOR RS-232 CONFIGURATION.
5. IF A GTN AND GNS 400W ARE INSTALLED, THE RS-232 LINES MAY BE CONNECTED TO CROSSFILL FLIGHT
PLANS AND USER WAYPOINTS FROM THE GTN TO THE GNS 400W. THE GTN MUST HAVE SOFTWARE
VERSION 3.00 OR LATER INSTALLED. THE GNS 400W MUST HAVE SOFTWARE VERSION 5.00 OR LATER
INSTALLED.
6. ANY AVAILABLE RS-232 PORT CAN BE USED IN LIEU OF PORT 3 ON THE GTN.
7. THE CONNECTED GNS RS-232 PORT MUST BE SET TO ‘GTN CROSSFILL’ AND THE GTN RS-232 PORT MUST
BE SET TO ‘GNS CROSSFILL’.
s
NOTES:
5
6
7
Figure H-40. GTN 6XX/7XX Crossfill Interconnect