Garmin GNS 530, Installation Manual

Page: 36 / 141

Page 4-10 500 SERIES INSTALLATION MANUAL
Rev Q 190-00181-02
4.5 ANNUNCIATORS/SWITCHES
4.5.1 Annunciators/Switches Function
NOTE
Initial certification of the 500 Series units was accomplished without use of any remote
switches or annunciators, since the same switching and annunciation is available on
the front panel of the 500 Series unit.
However, if the 500 Series unit is not installed in
the pilot’s normal field of view, some or all of the remote switches and annunciators may
be required by your certification agency. Appendix B includes an FAA letter granting
permission to install GNS 530 without external switches and annunciators.
4.5.1.1 MESSAGE ANNUNCIATE
When a new status message is available, the Message Annunciator flashes. When status messages remain
effective, the Message Annunciator illuminates.
4.5.1.2 WAYPOINT ANNUNCIATE
The waypoint annunciator output is driven in the following manner:
1. When the aircraft is within 10 seconds of reaching the turning point for a course change, the
waypoint annunciator flashes.
2. When the aircraft is in a turn, the waypoint annunciator illuminates and remains illuminated until
the turn is completed.
3. When a user arrival alarm is set and the aircraft is within the circle defined by the arrival alarm
radius at the arrival waypoint, the waypoint annunciator flashes for 10 seconds.
4. When a user arrival alarm is not set and the aircraft is within 10 seconds of reaching the arrival
waypoint, the waypoint annunciator flashes.
4.5.1.3 CDI SOURCE SELECT (GNS 530 Only)
This CDU Source Select input may be used to toggle between display of GPS and VOR/LOC/Glideslope
information on the MAIN external CDI/HSI. A momentary low on this pin performs the same function as
pressing the ‘CDI’ key on the GNS 530 bezel.
4.5.1.4 VLOC ANNUNCIATE (GNS 530 Only)
This VLOC Annunciator output is driven when the unit is configured with a single CDI/HSI and the
VOR/ILS data is being displayed on the CDI/HSI. This output parallels the VLOC annunciator on the
display.
4.5.1.5 GPS ANNUNCIATE (GNS 530 Only)
This GPS Annunciator output is driven when the unit is configured with a single CDI/HSI and the GPS
data is being displayed on the CDI/HSI. This output parallels the GPS annunciation on the display.
4.5.1.6 OBS MODE SELECT
This OBS Mode Select input may be used to toggle between GPS OBS and GPS AUTO modes of
operation. A momentary low on this pin performs the same function as pressing the ‘OBS’ key on the 500
Series unit.
4.5.1.7 OBS ANNUNCIATE
This OBS Annunciate output is driven to indicate GPS OBS mode of operation. This output is active when
the OBS or SUSP annunciation is on the display.
4.5.1.8 TERMINAL ANNUNCIATE
When performing approach navigation, the terminal annunciator is illuminated when operating within 30
nautical miles of the departure or arrival airport and the CDI scale is the equivalent or 1.0 nm or less.
4.5.1.9 APPROACH ANNUNCIATE
When performing approach navigation, the approach annunciator illuminates when approach is active.
4.5.1.10 INTEGRITY ANNUNCIATE
The Integrity Annunciator illuminates when the GPS receiver detects a position error, or is unable to
calculate the integrity of the position.