Garland ULTIMATE 820 QG, Instruction Manual, Page: 44 / 160

English
44/160
Be careful not to touch the hot parts of the machine
while the engine is running or after use, such as
exhaust, spark plug or high voltage cables.
Do not use other accessories this machine except
those recommended by our company since its use
could cause severe damage to the user, people close
to the machine and the machine itself.
7.1. HOLDING AND GUIDING THE MACHINE
While working, always hold the machine with both
hands on the handle.
Do not hold the machine with one hand.
7.2. WORKING WITH THE MACHINE
Select the nozzle most convenient for the job to be
carried out.
Connect the machine to a clean water hose.
Open the water tap. Start the machine following the
instructions in the manual.
Direct the gun to the surface to be cleaned.
Press the trigger of the gun to start to clean.
Cleaning:
To clean, hold the gun with both hands and direct the
high pressure water to the objects to be cleaned. Do
not get too close to the objects as you could damage
these. We recommend maintaining always a minimum
distance of 30cm. From the objects being cleaned.
Soaping:
Please use exclusively GARLAND detergents
and care products.
Danger: The use of wrong detergents or chemicals
can compromise the safety of the appliance.
The use of other detergents and care products may
lead to premature wear and can invalidate your
warranty claims.
Danger: The improper use of detergents can
cause severe injuries or toxication.
When using detergents, the material data safety
sheet issued by the detergent manufacturer must
be adhered to, especially the instructions regarding
personal protective equipment.
Install the suction soap tube on the machine and place
the aspiration tip in a soap container.
Place the low pressure nozzle on the lance. Tighten
the lance and soap the desired surface.
8. MAINTENANCE AND SERVICE
Perform the following maintenance operations
and care when you have finished working with
the machine to ensure the smooth running of this
machine in the future. For complete maintenance, we
recommend you take the lawnmower to your service
technician.
Before performing any maintenance or repair
on the machine make sure that the engine has
stopped and remove the spark plug pipe.