Garland ULTIMATE 820 QG, Instruction Manual

Page: 42 / 160

English
42/160
2. Place the fuel tap in the open position.
3. Place the air lever in the closed position .
4. Place the accelerator lever in the maximum
position .
5. Place yourself behind the machine, as shown in the
figure, and pull the Starter rope until the engine
starts.
6. If the machine starts and does not stop, slowly
begin moving the air lever toward the Open air
position (normal working position).
7. Adjust the appropriate number of revolutions with
the throttle lever.
8. Allow the engine to warm up for a few minutes
before starting to use the machine.
6.4.2.2. STARTING WITH A HOT ENGINE
Place the machine on a flat surface and stable to start
it.
1. If your machine has a security switch, place it on
the on starting position “ON”.
2. Place the fuel tap in the open position.
3. Place the air lever in the Open position
(Normal working position).
4. Place yourself behind the machine and pull the
Starter rope until the engine starts.
5. Adjust the appropriate number of revolutions with
the throttle lever.
6.4.3. CHECKPOINTS AFTER STARTING THE MACHINE
Check that when the trigger is not pressed, water
does not flow out under pressure through the lance,
hose or any connectors.
If you detect any of these leakages please tighten or
repair these parts.
It is important to pay attention to the possible
individual parts or and the temperature of the
machine. If you detect any anomaly in the machine
Normal working
position
Turtle = Minimum
Hare = Maximum