12
Part Number 4532415 Rev 5 12/15
INSTALLATION SAFETY—DISCLAIMER
DANGER
Installation must be carried out by registered installation
contractors only.
The contractors are responsible for interpreting all
instructions correctly and performing the installation
in compliance with all applicable national and local
regulations.
The warning signs and serial plates on the equipment
must strictly be followed.
n
Warning
This equipment is intended for indoor use only. Do not
install or operate this equipment in outdoor areas.
n
Warning
To avoid instability, the installation area must be capable
of supporting the combined weight of the equipment
and food product. The equipment must be level side to
side and front to back.
,
Caution
Consultants, fabricators and designers must consult their
counter-top suppliers when designing an appropriate
support structure and clearance for the counter-top and
the installation.
Notice
Induction equipment that is not installed correctly will
have warranty voided.
INSTALLATION SAFETY—CLEARANCE AND
VENTILATION
DANGER
Risk of Fire or Shock or Equipment Failure
All minimum clearances must be maintained. Air intake
vents and exhaust vents must not be blocked or be
restricted by the installation.
,
Caution
This equipment must only be operated under an
approved ventilation system in accordance with all
applicable national and local regulations. Exceptions
may apply.
Notice
The maximum ambient temperature for the
induction appliance to operate must not exceed
40°C [104°F].
Failure to provide adequate ventilation will cause
the appliance to overheat, to reduce power, or to
shutdown.
NOTE: Always maintain enough space between and
around the equipment for maintenance and service.
INSTALLATION SAFETY—ELECTRICAL
DANGER
All electrical connections must be carried out by a
certified electrical contractor, who is responsible for
the correct rating and installation of the appliance. The
contractor has to comply with all legal safety regulations
and all applicable national and local electrical codes.
n
Warning
Markings and warning labels mounted directly on the
equipment must be observed at all times and kept in a
fully legible condition.
n
Warning
This equipment must be positioned so that the plug is
accessible unless other means for disconnection from
the power supply, such as circuit breaker or disconnect
switch, is provided.
n
Warning
CE Induction Appliance only: If ground fault current
protective switches are used, they must be provided
with selective activation and designed for a minimum
fault current of 30mA.
Notice
Ensure the supply voltage and the line current match
the specifications given on the serial plate affixed to the
appliance. Wrong voltage will damage the appliance. A
stable power supply must be provided.
Notice
Always refer to the serial plate on the appliance to verify
the electrical data. When the data listed on the serial
plate is different than that listed in this manual, contact
the manufacturer or the authorized representative.