![background image](http://html1.mh-extra.com/html/gardner-denver/l23/l23_original-operating-and-service-manual_563814037.webp)
9 Control system
35
9.4
Displaying / changing values
9.4.1
Selecting values
You can display values, e.g., total hours, and set the
control system, e.g., cut-in and cut-out times, in the
sub-menu.
To reach the main menu, you must press the
+
buttons at the same time.
You can use the
or
buttons to switch between the
following sub-menus:
[MAINTENANCE
SCHED.]
[
CONTROL
MENU
]
[
FAULT
MEMORY
]
TIMER
CONTROL
[
LIMIT
VALUES
]
[OPTIONAL
IN-/OUTPUTS]
Enter a sub-menu by pressing the
button.
Again here you can use the
or
buttons to go to a
menu item.
To exit the sub-menu, you must press the
+
buttons at the same time.
To then fully exit the main menu, you must again press
the
+
buttons at the same time.
9.4.2
Changing values
Enter the sub-menu and then the menu item containing
the value you wish to change.
Then press the
button, the value flashes. You can
now press
or
to change the value. You must then
press the
button again to confirm the value.
9.5
Default settings
WARNING
When programming in standby, the
machine may start up at any time.
9.5.1
Selecting the language
You can change the language by simultaneously
pressing the
+
or
+
buttons. Press these
buttons at the same time until the right language
appears.
9.5.2
Setting system pressure
(except for L23RS-L29RS)
Max. system pressure:
The system pressure is set in the
[
CONTROL
MENU
]
sub-menu. To do so, press the
or
buttons at the same time. You are then taken to the
main menu. Use
to switch to the
[
CONTROL
MENU
]
sub-menu. Then please press the
button.
The
CUT-OUT
POINT
menu item now appears on the
display. Pressing the
button again causes the value
to flash. You can now change (increase or decrease)
this value by pressing
or
. Then confirm the value
set by pressing the
button.
NOTICE
When changing the system pressure, there is a
preset validity check. The maximum system
pressure CUT-OUT POINT must be at least 0.2
more than the minimum system pressure CUT-
IN POINT. You may therefore have to set the
minimum system pressure point first.
For example:
CUT-OUT
POINT
145 PSI
CUT-IN
POINT
142 PSI
Minimum system pressure:
In the
[
CONTROL
MENU
]
sub-menu please use
to go
to the
CUT-IN
POINT
menu item.
Pressing the
button causes the value to flash.
You can now change (increase or decrease) this value
by pressing
or
. Then confirm the value set by
pressing the
button.
Summary of Contents for L23
Page 2: ......
Page 61: ...12 Appendix 59 Fig 33 All dimensions in inches ...
Page 62: ...12 Appendix 60 Fig 34 All dimensions in inches ...
Page 63: ......