![background image](http://html1.mh-extra.com/html/gardner-denver/l23/l23_original-operating-and-service-manual_563814031.webp)
7 Preparation for Commissioning
29
Notes on the table:
Ultimately the type of cable you use, its length and
installation conditions (temperature, accumulation) are
outside the scope of our knowledge. Therefore the
above table only offers guidelines.
The gauges named in the table correspond to those in
UL508A. (Rubber sheathed cable at 86 °F and max.
55 yd cable length)
* If conditions differ (cable length, temperature and
accumulation) the gauge must be determined according
to UL508A. The cable type must also be taken into
consideration.
7.3.1
Check the motor protective relay
(only for L23RS-L29RS)
Check the setting of the motor protective relay
according to the attached compressor circuit diagram.
Set the protective switch according to the source
voltage and frequency from the value in the table (see
circuit diagram).
7.3.2
Check the control transformer
setting
DANGER
High Voltage – Hazard of Shock, Burn, or
Death.
•
The electrical connection should be
made by a qualified electrician.
•
Only perform checks and carry out work
on the screw compressor when the unit
is out of operation, depressurized, and
secured from being switched on again!
NOTICE
Incorrectly setting the control transformer poses
a risk to the trouble-free operating of the
system.
Checking the setting of the control transformer
is part of commissioning and part of regular
inspection/maintenance because the supply
voltage can change.
The correct setting should be checked by
measuring the control transformer
ʼ
s output
voltage while the system is running with a load.
The control-power transformer is factory-preset to the
rated voltage. However, practice has shown that the
actual supply voltage often differs from this value.
Before first commissioning, set the measured supply
voltage on the control transformer. Fig. 14 illustrates an
example.
Following first commissioning, the setting of the control
transformer must be inspected while operating under
load and corrected where necessary. (see Chapter
10.9).
Fig. 14
Summary of Contents for L23
Page 2: ......
Page 61: ...12 Appendix 59 Fig 33 All dimensions in inches ...
Page 62: ...12 Appendix 60 Fig 34 All dimensions in inches ...
Page 63: ......