A
B
e
s
Disassembling the plastic blade:
1. Turn the trimmer over.
2. Press end of blade down slightly
(A), slide blade
e
inside
through blade carrier
s
(B) and pull out.
Assembling the plastic blade:
v
Slide new blade
e
from inside through slot in metal of blade
carrier
s
until it snaps into place.
When the new blade is correctly inserted, it can be moved more
easily.
Problem
Possible Cause
Remedy
The Trimmer is not cutting
cleanly or not cutting at all
Blade worn or too short.
v
Replace blade.
Blade broken off.
v
Replace blade.
The trimmer vibrates severely
The blade is excessively worn
and creates an unbalance.
v
Replace blade.
The trimmer does not start
Battery is flat.
v
Charge battery
(see 3. Initial Operation).
Battery not pushed onto the
handle properly.
v
Push battery onto the handle
and make sure that the locking
buttons snap in correctly.
Motor blockage.
v
Unblock and restart the
device.
The trimmer stops.
ErrorLED
ß
W
flashes
Battery overload.
v
Wait for 10 sec.
Press button
ß
B
on the battery
and restart.
High temperature. The allowed
operation temperature was
exceded.
v
Leave battery to cool for
approx. 15 min. Press
button
ß
B
on the battery
and restart.
Charging control lamp
9
on
the charger does not illuminate
Battery charger or charging
cable not plugged in properly.
v
Plug in battery charger and
charging cable properly.
Charging control lamp
9
on
the charger flashes red
Charging error.
v
Unplug charger and plug
in again.
The trimmer stops.
ErrorLED
ß
W
flashes
Battery error /
battery defective.
v
Press button
ß
B
on the
battery and restart.
The battery can no longer
be charged
Battery is defective.
v
Replace the battery
(Art. No. 9839).
Only an original GARDENA BLi-18 Replaceable Battery (Art. 9839) may be used.
This can be obtained from your GARDENA dealer or directly from GARDENA Service.
22
EN
