17
9.3.6
Setting Up Continuous Output
Continuous output can be set up using Simple Set Up.
Set up continuous mode as follows. Note that pressing and holding MODE at
any time will cancel the operation. Do not set the output current higher than the
rating for the LEDs.
PP600 is ready
Use UP or DOWN
to select "CON"
Use UP or DOWN to select the required current in
amps.
Note that the "units" digit is flashing and that UP or
DOWN change the value by one. Pressing RANGE to
make the "tens" digit flash, causes the values to
change by ten. The "hundreds" and "thousands" digits
can also be selected using range.
PP600 sets the output
current.
Use UP or DOWN
to select which
output channel to
set up - "CH1" or
"CH2".
Press and hold SELECT for one second
Press SELECT
Press SELECT
Press SELECT
Wait one second
Wait one second
Press SELECT