38
ELECTRIC CONVECTION OVENS
EN
2.9 - Replacing and adjusting various parts
WARNING!
Parts replacement and adjustment work is classed as non-routine
maintenance, meaning it must be carried out by an authorized
installer.
Before starting any repair or maintenance work, you must switch off
the appliance at the main power source so to avoid any electrical
contacts. Also close the water supply tap.
Remember to restore and put back the seals, sealants and sheathing
inserted, before finishing the work.
2.9.1 - Replacing the safety thermostat
• The thermostat bulb is located on the
right of the cooking chamber, behind the
baking-pan support:
1) Open the right-hand side of the oven;
2) Remove the bulb inside the oven
chamber;
3) Remove the thermostat wires and
unscrew the fastener. (B - pict.8)
Secured to the back of the control
panel;
4) Put everything back in position.
Secure the probe and the electrical
connections.
2.9.2 - Oven lamp
Proceed as follows:
1) Open the oven door (A - pict. 9).
B
C
B
A
pict. 8
pict. 9
2.9.3 - Door seal
• The seal is pressed into place, therefore
it must be pulled out and pressed back into
place. This operation must be done by hand
so as not to damage the seal.
2.9.4 - Fan and motor
From inside the oven, remove the motor
protection, unscrew the unit that releases
the fan, remove the fan after taking off the
panel on the left-hand side of the oven.
CAUTION!
Do not damage the fan while removing or assembling it.
pict. 10
2) Turn the plastic clamps (B - pict. 9) which lock the internal glass and
open it up like a book.
3) Replace the bulb (C - pict. 9).
4) Reassemble everything in reverse order.
2 - Second Part_Installation instructions and maintenance
