IDL 101
HB_IDL101_E_V222.doc
3
Gantner Instruments Test & Measurement GmbH
General warning and safety instructions:
Dear customer,
We congratulate you on having selected a product of Gantner Instruments Test & Measurement GmbH (in the following:
Gantner Instruments). So that our product functions in your installation with safety and to your complete satisfaction, we take
this opportunity to familiarize you with the following ground rules:
1.
Installation, commissioning, operation and maintenance of the product purchased must be carried out in accordance
with instructions, i.e. in accordance with the technical conditions of operation, as described in the corresponding
product documentation.
2.
Before either installation, commissioning, operation or maintenance it is therefore essential that you read the
corresponding chapter of this manual and observe its instructions.
3.
If there are still some points on which you are not entirely clear, please do not take a chance, but ask the customer
adviser responsible for you, or ring the Gantner Instruments hotline.
4.
Where not otherwise specifically laid down, appropriate installation, commissioning, operation and maintenance of the
appliance is the customer’s responsibility.
5.
Directly on receipt of the goods, inspect both the packaging and the appliance itself for any signs of damage. Also
check that the delivery is complete (-> accessories, documentation, auxiliary devices, etc.).
6.
If the packaging has been damaged in transport or should you suspect that it has been damaged or that it may have
a fault, the appliance must not be put into service. In this case, contact your customer advisor. He will make every
effort to resolve the problem as quickly as possible.
7.
Installation, commissioning and servicing of our appliances must only be carried out by suitably trained personnel. In
particular, electrical connections may only be made by correspondingly qualified specialists. Here, the appropriate
installation provisions in accordance with the relative national Electrical Engineers construction regulations (e.g. ÖVE,
[Austrian] VDE, [German]...) must be observed.
8.
Where not otherwise stated, installation and maintenance work on our appliances is exclusively to be carried out
when disconnected from the power supply. This applies in particular to appliances which are normally supplied by
low-tension current.
9.
It is prohibited to make alterations to the appliances or to remove protective shields and covers.
10.
Do not attempt yourself to repair an appliance after a defect, failure or damage, or to put it back into operation again.
In such cases, it is essential you contact either your customer adviser or the Gantner Instruments hotline. We will
make every effort to resolve the problem as quickly as possible.
11.
Gantner Instruments accepts no responsibility for any injuries or damage caused as a result of improper use.
!