STRONG. SIMPLE. COMPACT.
Rev Date 23 0610
800.285.6780 [email protected]
EDGE
INSTALLATION MANUAL PAGE 7
LED Fixture Electrical Connections
•
The LED Output connectors on the circuit board inside the
EDGE
PDT are labeled 1A, 1B, 2A, and 2B.
•
The system layout that is included with the system identifies which leaders connect to which string of lights.
For instance, leader 1A must be connected to output 1A, and leader 2A must be connected to output 2A.
Failure to make the correct connections will lead to lighting effects being generated in an erratic manner.
•
To connect the leader cables to the LED Output terminals, remove 2-3” of the black outer insulator of the
leader cable. Strip 3/8” of insulation off the blue, red, white, and black wires. Connect these wires to the
“LED OUTPUT” terminals as shown in the table and photo below. Trim back the green wire and the shield
around the blue and red wires; they are not used in the
EDGE
system.
LED Output
Terminal
Leader Cable
Wire Color
D- (Data Minus)
Blue
D+ (Data Plus)
Red
V- (0 VDC)
Black
V+ (48 VDC)
White
