STRONG. SIMPLE. COMPACT.
Rev Date 23 0610
800.285.6780 [email protected]
EDGE
INSTALLATION MANUAL PAGE 9
COLORWASH INSTALLED OPTION
Control Board
•
The required connections to the PDT Board are installed at the factory.
•
A Reset Button is located on this board next to the ethernet port J1.
•
Ethernet Network connectivity to ethernet port J1 is required to adjust the settings stored on the controller.
Network Connectivity
In order to configure the ColorWash portion
of your EDGE system, it must have a
connection to the internet. The connection
is made using the RJ45 connection port on
the control board. This ethernet connection
must have access to outside networks.
The network cannot be restricted to local
connections only. Enterprise networks may
block outgoing connections using a firewall.
If this is the case, the following ports must
be opened for outbound connections to
allow the device to connect to our servers:
User Interface
•
In order to access the ColorWash system, you will need to create an account on the ColorWash dashboard
at https://dashboard.colorwash.app.
•
Requests for new accounts can also be sent to our support team at [email protected] or (800)-285-6780.
You will need to provide our team with a valid email address. An invitation link from colorwash@colorwash.
app will be sent to that email. Click the Create Account button to access the registration form.
•
After your account has been created, you can access the dashboard and adjust the settings for your system.
•
For information about configuring your system using the dashboard, please refer to the ColorWash
Dashboard User Guide. This can be found on the G&G website at www.ggled.net.
QUESTIONS?
Please contact G&G Support at 800.285.6780
Port
TCP
UDP
Usage
31314
Initial device-server connection
993
Fall-back device-server connection #1
443
Fall-back device-server connection #2
80
Fetch device firmware
