background image

STRONG. SIMPLE. COMPACT.

Rev Date 23 0610

800.285.6780   [email protected]

EDGE

 INSTALLATION MANUAL PAGE 4

Mounting the 

EDGE

 Fixtures

•  EDGE

 series wet location fixtures are typically surface mounted (Walls, Soffits, etc.). If mounting to the 

building soffits, it is recommended to mount the fixtures on the outer edges of the soffits to maximize 
the distance from the building walls. Fixtures should be aimed downward and slightly inward toward the 
building for the best effect. 

• 

Each fixture has an input (male) and output (female) end.  The end of the fixture with the product 
identification label is the input end. The fixture must be installed with the input end oriented in the 
direction of your incoming power source or leader cable.

• 

The location of the fixtures must follow your site-specific layout.

• 

For long linear runs, G&G recommends using a chalk line or laser to mark the mounting bracket locations. 

• 

2’, 4’, and 6’ fixtures require at least two mounting brackets. Brackets should be installed near the ends of 
the fixtures. 8’ models require three brackets with the third bracket being installed near the center of the 
light fixture.

• 

This product makes use of a push-click connector system. An audible click upon insertion of the connector 
indicates that the connector is fully seated. Failure to fully seat connectors can lead to cable and fixture 
damage during use. 

Connect the power leader cable to 
the input connector (male) on the LED 
fixture. To do this, align the connectors, 
push inward, and listen for the audible 
click sound that indicates that the 
connector is fully seated.

When daisy chaining fixtures continue mounting fixtures and 
attach jumper cables as needed using the same push-click 
connection method as the leader cable.

Mount the fixture(s) in their specific location using the Surface Mount Bracket to affix directly to the ceiling or soffits.

Summary of Contents for EDGE










Reviews: