G&D DP1.2-Vision-IP-Fiber, Installation And Operation Manual

Page: 148 / 240

Establishing a KVM-over-IP™ connection for the first time
G&D DP1.2-Vision-IP-Fiber · 23
English
Configuring a KVM-over-IP connection of a computer
module
You can carry out the required configuration settings directly on the console.
Configuring the network interface
How to configure the network interface:
1. Use the remote hotkey
Ctrl
+
Num
to open the OSD.
2. Select the entry
Network setup
and press
Enter
.
3. Select the entry
Interfaces
and press
Enter
.
4. Enter the following data under
Transmission
:
5. Press
F2
to save your settings.
NOTE: Use the local hotkey (default: Alt + Num ) to open the local OSD to configure
the network interface of the console module , or use the remote hotkey (default:
Ctrl + Num ) to open the remote OSD to configure the network interface of the com-
puter module.
The settings of both hotkeys are shown during the starting process of the console
module (see Starting process on page 16).
IMPORTANT: The OSD of the computer module can be opened only if a
KVM-over-IP
connection to the computer module is established.
Therefore, you have to change the configuration of the computer module
first
.
Operational
mode:
Press F8 to select the operational mode of the interface:
 Static:
A static IP address is assigned.

DHCP: IP address is obtained from a DHCP server.
 Off:
switches off network interface.
IP address: Enter the IP address of the interface.
The operational mode DHCP does not allow making entries.
Netmask: Enter the netmask of the network.
The operational mode DHCP does not allow making entries.