© Galvin Engineering Pty Ltd
Product Installation Guidelines
Version 1, 19 October 2022, Page
16
of
25
11.0
MAINTENANCE
When installed as an AS/NZS 4032.4 application it is a requirement that the Commissioning (Section 8.0
Commissioning) and maintenance procedures (Section 11.0 Maintenance) are carried out before use.
11.1
MIXED WATER TEMPERATURE ADJUSTMENT
1.
t v te the ‘Temp r ry ff’ fun t n Disassemble
spout, locking nut, flange and faceplate. Do not
disconnect the sensors cables.
2. Screw back the locking nut, without the faceplate.
3. Insert spout (without faceplate and flange) and
secure.
4. Using wrench size 23mm untight the tightening
ring
t v te the ‘C nt nu us run’ fun t n and
using wrench 16mm adjust the temperature by
turning the adjustment rod in direction marked on
the body. When the mixing temperature is set,
holding the adjustment rod tight the tightening ring
to prevent changing the adjustment. Stop the
‘C nt nues run’ fun t n.
Note:
Turning the setting screw clockwise will decreasing the
mixed water temperature and turning it counterclockwise will
increasing the mixed water temperature (see marking on the body).
Locking nut
Spout
Adjustment rod
Tightening ring
Spout
Locking nut
Flange
Face plate
Sensor
