EN - 71
EN
3.
Make sure that the supply cord is not damaged and does not go through the oven
or through any other sharp or hot places.
4.
Do not remove the light brown coverthat is attached to the oven cavity to protect the
magnetron.
5.
Place the oven as far away from radios and TV as possible. Operation of microwave
oven may cause interference to your radio or TV reception.
The
el. outlet must be
easily accessible in order
that the oven can be easily
disconnected from the el.
outlet in case of danger.
The appliance is equipped
with a
supply cord with
protective conductor. The
fork must be plugged into
a
properly wired and grounded
socket according to EN! We
recommend using an individual
electric circuit with a
safeguard
16 A
.
Turntable Ring Installation
1.
Open the oven door and insert the turnable
ring. Put the glass tray on the top of the
turntable ring, so that the central point of the
glass tray sits on the turntable shaft at the
bottom of the oven.
2.
Never place the glass tray upside down.
The glass tray should be restricted.
3.
Both glass tray and turntable ring assembly
must always be used during cooking.
4.
All food and containers of food are always
placed on the glass tray for coking.
5.
If glass tray or turntable ring assembly cracks
or breaks, contact nearest autorized service
center.
NOTE:
If the mw oven does not work properly, unplug it from the el. outlet, wait for 10
seconds
and then connect it again
Ventilation
Proper ventilation is necessary for cooling of the MW. If the ventilation openings are
covered during the operation of the MW, the MW will overheat. In such case, a
heat fuse
will turn the MW off. The MW oven will not work unless it has cooled down sufficiently. Air
coming from the ventilation openings may heat up during operation. This is normal. Steam
is a
normal product of cooking. The MW is designed in order that this steam is released
through ventilation openings on the side and in the back of the appliance.