6 WAY ..XOVER
...... . in this operating mode, the DS-SP36 is configured as a Mono Input to 6 Output
X-Over, where the Input A is automatically assigned to the Outputs as follow:
– Input A to Outputs 1,2,3,4,5 and 6 [Out1=Near-1, Out2=Near-2, Out3=Mid-1 and Out4=Mid-2, Out5=Far-
1, Out6=Far-2]
3x2 WAY ..XOVER
..... . in this operating mode, the DS-SP36 is configured as a 3 Input to 6 Output X-Over,
where the Inputs are automatically assigned to the Outputs as follow:
– Input A to Outputs 1 and 2 [Out1=Low-A and Out2=High-A]
– Input B to Outputs 3 and 4 [Out3=Low-B and Out4=High-B]
– Input C to Outputs 5 and 6 [Out5=Low-C and Out6=High-C]
By pressing ENTER on the System Setup page and rotating the “PM2” or “PM3” encoder, it is possible to
select all the available X-Over preset modes.
When the “2x3 WAY XOVER” is selected, the “System Setup” page will appear as follows:
To change the desired operating mode for the DS-SP36, the screen must reflect the X-Over required and
then simply pressing the “ENTER” button will bring up the following screen asking for confirmation to load
the selected operating mode:
If confirmed by pressing ENTER, the selected preset mode will load. While the device is configuring the
X-over the following screen will be appear:
The new preset mode will now be shown with an asterisk.
– Input Routing:
the DS-SP36 Processor is equipped with 3 Analog Inputs (Balanced Female XLR) and a
stereo S/PDIF Digital Input (RCA connector).
The “Routing Options” page allows you to select the desired Input type:
7
Please Wait.....
Changing Xover
New Xover
[ENTER] to confirm
System Setup
Setup: 2x3 WAY XOVER
SYSTEM UTILITY
– Input Routing –