In order to edit the parameters of any single process, enter the process editing page by pressing
the “ENTER” button and leaving it. Once finished editing, by pressing the “QUIT” button to go back
to the Editing Parameters sub-menu and select the new process to edit by scrolling through the
processes with the NAVIGATION encoder.
Routing
- from this page it is possible to assign either one of the 2 inputs of the DS-CP22 to the
currently edited Channel’s processes and Output.
So, it is possible to assign to the processes of Channel A and its Output, Input A, B or (A+B).
The selection can be operated using the PARAMETER encoder.
Input Gain
- from this page it is possible to adjust the Input Level digitally (after the A/D
converters) ranging from -12dBu up to +6dBu, by steps of 0.5dBu.
The adjustment can be operated using the PARAMETER encoder.
Noise Gate
- from this page, it is possible to set the parameters of a Noise Gate placed at the
beginning of the all dynamic and Eq. Processes.
Threshold
- the Noise Gate Threshold can be set as -80dBu, -85dBu, -90dBu or as OFF. When
OFF, the Noise Gate is just bypassed.
Release Time
- it is the time taken to un-mute the output once detected again an input signal over
the set threshold. It can range from 5ms to 100ms, by steps of 1ms up to 10ms, and of 10ms from
10ms up to 100ms.
Attack Time
- is the time taken by the Noise Gate to enter the Output Mute condition once the Input
Signal is detected to be below the Threshold. It can range from 0.5 seconds up to 2 seconds by
steps of 0.1 seconds.
The adjustment of the parameters can be operated using the PARAMETER encoder.
Ch.A Routing
< Input A >
Ch.A Input Gain
< 0.0dB >
Ch.A Noise Gate
< Attack = 0.5s >
15
