18
Cleaning the filter
Cleaning the filter should only be completed by a competent person.
1. Turn the shower electrical isolating switch off (at the consumer unit or mains fuse).
2. Isolate the water supply to the shower.
3. Carefully remove badge and loosen the fixing screw, then lift off the cover
4. Unscrew the two screws on the filter protective cover and remove the filter
assembly
5. Clean the filter assembly as necessary.
6. Refit the filter assembly and protective cover. Reassemble the unit in reverse
of the above procedure.
Cleaning & maintenance
Your electric shower unit should be cleaned using only a soft cloth and washing up liquid.
DO NOT USE ABRASIVE CLEANERS.
To reduce the requirements for chemical decaling in hard water areas, the shower head incorporates
rub clean teats. Any scale build up that may occur in any of the holes can be broken down by gently
rubbing the flexible tips of the jets during use. This procedure should be completed regularly, as often
as once a week in some hard water areas as scale build up can affect the spray pattern and cause the
shower to perform poorly.
Should chemical descaling of the headset become necessary, remove the shower head and fully
immerse in a mild propriety descalent.
IT IS IMPERATIVE THAT DESCALING IS CARRIED OUT STRICTLY IN ACCORDANCE WITH THE
MANUFACTURERS INSTRUCTIONS. SUBSTANCES THAT ARE NOT SUITABLE FOR PLASTICS AND
ELECTROPLATED SURFACES MUST NOT BE USED.
