8
4-4. The function of Copier
One can use the copier to pair a new transmitter or receiver, procedures as
follows:
1. Insert the six pins female plug of copier into the male socket inside the TX
or RX of SAGA1-L40.
2. For copying and saving the data from TX or RX, put on the magnetic key
onto the receptor to connect; for transferring the saved data from copier
to TX or RX, release the magnetic key from the receptor.
3. Press and release “1” pushbutton (or 2, 3) to copy and save the data
(When magnetic key is on) from TX or RX, after the green indicator light
has flashed, the transfer is finished, disconnect the plug. Proceed the
same procedure to transfer the data from copier to TX or RX. (When
magnetic key is off)
Note:
1. Make sure the power of TX or RX is “OFF” when copying.
2.The copier for SAGA1- L40 (dual colors on the appearance) can also
be used for existing SAGA1-L4/6/8/6B/8B/L10/L12.
3.The copier can copy both function settings and ID-Code, but to pair the
crystal is still essential to match both TX and RX for communicating
each other.
4-5. Change of Frequency
It is easy to change frequency of the SAGA1-L series simply by replacing
correspondent frequency crystal in both the TX and RX.
Note
: To replace a new crystal, please note that there are two kinds of
frequencies (VHF and UHF) available. The indication of VHF
or UHF is shown on PC board with a check mark “V” and
please make sure not to replace a VHF crystal unit into UHF
PC board or vice versa
.
