Gaggenau CI 282 602, User Manual

Page: 28 / 48

en-us
Operation
28
Food Cookware Frying sensor level Total frying time after the
signal (min)
Toasting pine nuts 4 3 - 15
7.12 Wireless cooking sensor
Before you use the cooking functions for the first time, es-
tablish the connection between the wireless cooking sen-
sor and the control panel.
Preparing and maintaining the wireless cooking
sensor
This section provides you with the following information:
¡
Attaching the silicone patch
¡
Using the wireless cooking sensor
¡
Cleaning
¡
Replacing the battery
You can retroactively purchase the silicone patch and
cooking sensor from specialist retailers, our technical cus-
tomer service or our official website. When doing so, quote
the relevant reference number:
00577921 Set of 5 silicone patches
CA060300 Cooking sensor and set of 5 silicone
patches
Attaching the silicone patch
The silicone patch secures the cooking sensor to the
cookware. If you are using an item of cookware with the
cooking functions for the first time, attach the silicone
patch to the cookware. Note:
1.
The part of the pan to which the patch is to be adhered
must be free of grease. Clean the cookware, dry it thor-
oughly and wipe the area where the patch is to be ad-
hered using alcohol, for example.
2.
Remove the protective film from the silicone patch. Ad-
here the silicone patch in the correct place on the out-
side of the pan using the supplied template as a guide.
3.
Press down all over the surface of the silicone patch, in-
cluding in the center.
The adhesive requires 1 hour to fully cure. Do not use
or clean the cookware during this time.
Notes
¡
The cookware with the silicone patch must not be left to
soak for long periods in soapy water.
¡
If the silicone patch comes loose, use a new one.
Attaching the wireless cooking sensor
Place the cooking sensor squarely onto the silicone patch.
Notes
¡
Ensure that the silicone patch is completely dry before
attaching the cooking sensor.
¡
Position the cookware in such a way that the cooking
sensor is pointing towards the outer side of the cooktop.
¡
To prevent overheating, do not align the cooking sensor
to any other hot cookware.
¡
When you are not using the cooking sensor, remove it
from the cookware and store it in a clean, secure loca-
tion, away from any heat sources.
¡
You can use up to three cooking sensors at the same
time.
Connecting the wireless cooking sensor to the control
panel
The cooking functions are available as soon as the wire-
less cooking sensor has been connected to the control
panel correctly.
1.
Select the basic setting ⁠ ⁠.
→
"Basic settings", Page 31
a
lights up white.
2.
Press ⁠.
a
A signal sounds.
a
lights up orange.
3.
The cooking zone indicators light up white and the
cooking sensor indicators on the cooking zones flash.
4.
Briefly touch the symbol on the wireless cooking sen-
sor within the next 30 seconds.
After a few seconds, the status of the connection be-
tween the cooking sensor and the control panel is indi-
cated.
Detection successful
¡
The wireless temperature
sensor is detected within a
few seconds.
¡
Three short beeps sound and
the symbol changes from
orange to white.
¡
The cooking sensor indica-
tors on the cooking zones go
out.