Gaggenau CI 282 602, User Manual

Page: 29 / 48

Operation
en-us
29
Detection failed
¡
Five beeps sound.
¡
The symbol changes im-
mediately from from orange
to white.
¡
The cooking sensor indica-
tors on the cooking zones go
out.
Note
The connection may not be established correctly for the
following reasons:
¡
Bluetooth® communication error.
¡
You have not pressed the symbol on the cooking
sensor within 30 seconds after selecting the cooking
zone.
¡
The battery in the wireless cooking sensor is almost
flat.
5.
If the connection has failed, reset the wireless cooking
sensor and repeat the connection procedure.
→
"Resetting the wireless cooking sensor", Page 29
6.
If there are problems with the connection due to a trans-
mission error, repeat the connection procedure.
7.
If no connection can be established, inform Customer
Service.
Resetting the wireless cooking sensor
1.
Press and hold for 8 to 10 seconds.
a
While you keep the touch key pressed, the LED indica-
tor on the wireless cooking sensor lights up three times.
2.
When the LED lights up for the third time, release the
touch key.
a
The reset procedure starts.
a
When the LED goes out, the wireless cooking sensor
has been reset.
3.
Repeat the connection process.
→
"Connecting the wireless cooking sensor to the con-
trol panel", Page 28
Cleaning
Do not clean the wireless cooking sensor in the dish-
washer.
Cooking sensor
Clean with a damp cloth. Do not place in the dishwasher
and do not get it wet.
When you are not using the cooking sensor, remove it
from the cookware and store it in a clean, secure location,
away from any heat sources.
Silicone patch
Clean and dry before attaching the cooking sensor. Suit-
able for dishwashers.
Note: The cookware with the silicone patch must not be
left to soak for long periods in soapy water.
Cooking sensor window
The cooking sensor window must always be clean and
dry. Note:
¡
Remove dirt and oil splatters regularly.
¡
For cleaning, use a cloth or q-tips and window cleaning
solution.
Notes
¡
Do not use hard or rough objects such as bristle
brushes or scouring pads to clean the cooktop, and do
not use scouring agents.
¡
Do not touch the window of the wireless cooking sensor
with your fingers; this will soil or scratch it.
Replacing the battery
If the cooking sensor does not light up when you touch the
symbol, the battery has discharged. Replacing the battery:
1.
Remove the silicone cover from the lower section of the
cooking sensor casing and remove both screws using a
screwdriver.
2.
Open the cap on the cooking sensor. Remove the bat-
tery from the lower section of the casing and insert a
new battery. In doing so, pay attention to the correct
alignment of the battery terminals.