Installation instructions
en
47
21.7 Installing the appliance
ATTENTION!
Sharp-edged screwdrivers may damage the control
panel.
▶
Use a suitable screwdriver.
▶
Do not scratch the control panel.
1.
Observe the clearances when installing in a tall unit.
When installing 2 appliances next to each other,
align both handles to the centre.
2.
If there is no intermediate floor above the appliance,
secure the appliance against tipping in the unit. Se-
cure two commercially available brackets on both
sides in the unit at a depth of 450 mm, 5 mm above
the height of the appliance.
3.
Push the appliance all the way into the built-in unit.
‒
Do not kink or trap the connection cable, or
route it over sharp edges.
4.
Centre the appliance.
There must be an air gap of at least 2 mm between
the appliance and the adjacent unit fronts.
5.
Use a spirit level to adjust the appliance so that it is
perfectly level.
6.
Open the appliance door.
7.
Secure the appliance using the enclosed screws.
‒
First, secure the appliance in place in the unit us-
ing the lower screws .
‒
Screw on the two upper screws .
8.
Remove the transit bolt from the door.
21.8 Aligning the appliance door
The appliance door is already aligned when the appli-
ance is delivered. Alignment is not normally required.
If required, you can adjust the appliance door's align-
ment at the hinge in order to achieve a precise gap.
Summary of Contents for BOP2201.2
Page 1: ...en User manual and installation instructions BOP2201 2 BOP2211 2 Oven Gaggenau...
Page 50: ......
Page 51: ......
