G-U RZ 25, Installation And Operating Instructions Manual, Page: 33 / 40

33
Resetting the maintenance timer
 
Put DIP switch S6 in the „ON“ position
 
Press the reset button for 5 s.
Once 5 s have elapsed, LED H2 in the control unit
flashes rapidly to acknowledge this.
 
Put DIP switch S6 back into the „OFF“ position
Resetting the battery replacement timer
 
Put DIP switch S6 in the „ON“ position
 
Press the reset button for 25 s.
As soon as 25 s have elapsed, LED H2 in the
control unit flashes rapidly to acknowledge this.
 
Put DIP switch S6 back into the „OFF“ position
7.3 Restoring the delivery condition
ATTENTION:
all
settings and operating data are reset when the procedure described below is
carried out!
You can reset the RZ 25/RZ 50/RZ 75 compact control
units to their delivery condition as described below:
 
Apply jumper J1
 
Press the reset button for 25 s (after 5 s, visual
confi rmation is provided that the bus settings have
been reset)
 
Remove the jumper J1.
7.4 Cleaning
Clean the housing with a soft slightly damp cloth. Only use water or a mild pH-neutral detergent in
diluted form.
Never use aggressive cleaning products containing acid, scouring agents or detergents with
corrosive ingredients.
7.5 Warranty
All deliveries are made on the basis of our General Terms and Conditions
The guarantee complies with the legal regulations and is valid in the country where the product was
purchased.
The guarantee covers material and manufacturing defects occurring under normal stress.
NOTE
Maintenance display DIP switch
Reset button of compact control unit
Jumper J1 applied
Reset button of compact control unit