20
21
N i M H 2 . 0 A 9 . 5 2 V
A U T 0 0 0 : 1 3 0 0 0 0 0
CHARGING
/
BATTERY IN RE-PEAK
CHARGE MODE
NIMH NICD
Re-peak Charge Mode (NiCd and NiMH batteries only): In re-peak charge
mode, the charger can peak charge the battery once, twice or three times in
a row automatically. This is good for confirming the battery is fully charged,
and for checking how well the battery receives fast charges. A five minute
cool-off delay occurs after each re-peak charge. See the diagram below for
using re-peak charge mode. To start charging, press the Start/Enter button
for 3 seconds.
NIMH/NICD BATTERY PROGRAM
The screen indicates the discharging state. You
can press Start/Enter key to alter discharge
current. Press Start/Enter again to store the
value. Press Batt Type/Stop key to stop
discharging. The emitted sound alerts the end
of discharging.
Elapsed
time
Charged
capacity
Battery
type
Charge
current
Battery
voltage
N i M H R E - P E A K
1
N i M H 2 . 0 A 9 . 5 9 V
R P C 0 0 0 : 3 3 0 0 0 1 7
“Re-peak cycle: 1” shows on the display. Press
the Start/Enter button to make the re-peak cycle
number blink and press the / button to find
the desired number of times to re-peak. Press the
Start/Enter button to confirm selection.
Battery
type
Charge
current
Battery
voltage
Elapsed
time
Charged
capacity
CHARGE/DISCHARGE & DISCHARGE/CHARGE CYCLE
OF NIMH/NICD BATTERY
Battery
type
Elapsed
time
Battery
voltage
Discharged
or charged
capacity
Discharge
or charge
current
NiMH CYCLE
CHG
＞
DCHG 1
NiMH 1.0A 7.42V
C>D 022:45 00890
You can set up sequence on the left and the
number of cycles on the right. Range of the
cycle number is 1-3.
Press Batt Type/Stop key to stop program, you
can press Start/Enter key to alter charge
current. The sound indicates the end of
program.
NIMH/NICD BATTERY PROGRAM
Start
Enter
Start
Enter
Batt type
Stop
'> 3 seconds '
- +
- +
- +
