51834295_V_1_7.DOC
37/60
5. SETUP
5.1 Installation
Install the device on a plane surface.
Rack-installation: This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the front panel and the rear panel. The rack should be provided with a cooling fan.
When mounting the controller into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the controller with four screws M6 in the rack.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
5.2 Sound-control
The sound-control either works via the ¼” mono jack-socket or the built-in microphone.
If the CP-512/64is supposed to work via a sound signal at the Audio In-socket, connect the ¼" jack socket
with the sound signal of your headphones output or a second adjustable output (if existing) of your mixer, or
with the loud-speaker output of your amplifier.
Tip:
Data +
Sleeve: Ground
Caution:
Never connect the sound input with the DMX-output, as this will destroy the electric (DMX-driver).
5.3 DMX-512 connection with the projector
Projector 1
Starting address 1
Projector 2
Starting address 33
Projector 3
Starting address 65
The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
