Before use
39
ŵŖœœřŶť
ŦūŃŰŲŧŨ
*W;<<B&`B%37&`]&=
&`)B %37B&`]&
)! "# " @EFFG% '"
Q%J
⇔
G') $
* W;<<B&`
allocations as described in the table below.
1 Turn on the receiver. (At this moment, the
transmitter should be off.) Then, LED blinks
RED in about 3 seconds. Next, wait until it
becomes solid RED.
2 Press and hold the Mode switch more than 5
seconds.
3 Release the button when the LED blinks RED
and GREEN simultaneously.
4 The receiver is now in the "Operation CH Set"
mode. At this moment, the LED indicates
that corresponds to the CH mode.
Mode A
Mode B
6/SB
6CH
S.BUS
Red LED blink
1 time
2 time
W;<<B&`'7
Default CH mode
*Cannot exit this CH setting mode before the operation mode is
,+
&¤'
¤@^$
$' ¤7"B'#¤
5 By pressing the Mode switch, the operation
CH is switched sequentially as " Mode A"
"Mode B" "Mode A"....
6 The operation mode will be set by pressing
the Mode switch more than 2 seconds at the
desired CH mode.
7 Release the button when the LED blinks
RED and GREEN simultaneously. Then, the
6 After confirming the operation CH mode is
changed, turn off and back on the receiver
power.
* 5 ' &
receiver communicates to the transmitter.
PWM 6ch
S.BUS
WARNING
Q%JZ
D o n ' t c o n n e c t s e r v o f o r
conventional system to S.BUS
port.
$ ¦
¦
,
