Furuno NAVpilot-700, Installation Manual

Page: 66 / 100

3. INITIAL SETTINGS
3-30
Speed calculation
Speed is normally entered automatically, from your navigator. If the navigator fails, man-
ually enter speed.
1. Rotate the knob to select [SPEED CALCULATION] from the [PARAMETER SETUP]
menu.
2. Push the knob to the options for [SPEED CALCULATION].
3. Rotate the knob to select [AUTO] or [MANUAL] then push the knob. For [AUTO] go to
step 5. For [MANUAL], do as follows:
1) Rotate the knob to select the current value and push the knob.
2) Rotate the knob to set a value (0.1 - 99.0).
4. Push the knob to finish.
3.13 AUTO OPTION Menu
.
Item Description Settings
[ADVANCED
AUTO] The AUTO mode will maintain a set course, but
your vessel's course may be shifted by the
effects of tide and wind. To compensate for the
effects of tide and wind, set [ADVANCED AUTO]
to [ON]. Your NAVpilot must be connected to a
GPS navigator which outputs position data (Lati-
tude and Longitude) in CAN bus or NMEA 0183
format. [OFF], [ON]
MANUAL
AUTO
AUTO OPTION
ADVANCED AUTO: ON
NET TOWING AUTO*: OFF
CSE AFTER REMOTE:
PRESENT COURSE
*: Not shown when BOAT TYPE is set
for “sailboat”.
AUTO OPTION
ADVANCED AUTO: ON
For Fantum Feedback
TM
For RRU