Furuno NAVpilot-700, Installation Manual

Page: 53 / 100

3. INITIAL SETTINGS
3-17
3.6 CAN bus Port Setup
The [CAN BUS SETUP] menu sets up the equipment connected to the CAN bus port.
1. The cursor is selecting [DEVICE LIST]; push the
knob.
This displays shows the name of the CAN bus
equipment connected to the CAN bus port. (In
the example illustration, the FURUNO Heading Sensor PG-700 is connected. The
series of alphanumerics which follow the model name are the CAN bus unique num-
ber.) The name of the device can be changed. If you do not need to change the name,
go to step 3.
2. To change the device name, do the following:
1) Push the knob.
2) Rotate the knob to select character then push the knob.
3) The cursor moves to the next character. Repeat step 2 to change the character.
You can select the input location with the
W
and
X
keys. The name can have a
maximum of 14 characters.
3. Press the MENU key to go back to the [CAN BUS SETUP] menu.
4. Rotate the knob to select [INCOMING CAN BUS DATA] to show the following display.
This display shows all the NMEA 2000 sentences that the NAVpilot is capable of
receiving. The Parameter Group Number (PGN) the NAVpilot is currently receiving are
highlighted.
5. Press the MENU key to go back to the [CAN BUS SETUP] menu.
CAN BUS SETUP
DEVICE LIST
INCOMING CAN BUS DATA
SELECT OUTPUT PGN LIST
REFRESH: NO
DEVICE LIST
PG-700: 0019E4
INCOMING CAN BUS DATA
126992
127488
129026
129285
130313
126464
127258
129025
129284
130312
126208
127251
128267
129283
130311 059904
126996
127489
129029
130306
130314
060928
127250
128259
129033
130310
130577