Furuno NAVpilot-700, Installation Manual

Page: 42 / 100

3. INITIAL SETTINGS
3-6
3.5 Dockside Setup Menu
The dockside setup menu for RRU and Fantum Feedback
TM
is different.
3.5.1 Dockside setup for RRU
RRU type
1. The cursor is selecting [SELECT RRU TYPE]; push the knob.
2. Rotate the knob to select correct option then push the knob.
[ROTARY(INBOARD)]: For FURUNO Rudder Reference Unit
FAP-6112.
[LINEAR(OUTBOARD)]: For Teleflex linear sensor AR4502.
RRU sensor alignment
3. Go back to the [DOCKSIDE SETUP] menu.
4. Rotate the knob to select [RRU SENSOR ALIGNMENT] then push the knob.
5. With the rudder physically centered, confirm that the displayed rudder angle indication
is less than or equal to ±5
°
. If not, you must adjust the rudder sensor body or magnet
position (for Teleflex linear sensor AR4502) so that the indicator is within ±5
°
before
continuing.
DOCKSIDE SETUP
* Displayed if Accu-Steer drive
unit is selected.
SELECT RRU TYPE
ROTARY(INBOARD)
RRU SENSOR ALIGNMENT
AIR BLEEDING: NO
RUDDER LIMIT SETUP
AUTO RUDDER LIMIT:
MANUAL RUDDER LIMIT:
RUDDER TEST: NO
HELM SENSOR TEST*
SAFE HELM/P.ASSIST SETUP*
ROTARY(INBOARD)
LINEAR(OUTBOARD)
0
0
NAVpilot-700
MEASURE RUDDER CENTER
POSITION AND CONFIRM
DISPLAYED VALUE IS <5
°
.
IF NOT, ADJUST RRU ARM OR
MAGNET. NAVPILOT WILL
CORRECT REVERSED P & S
INDICATION LATER.
PUSH ANY KEY TO CONTINUE
RRU SENSOR ALIGNMENT
ALIGNMENT TONE:
ON
Press any key.
RRU SENSOR ALIGNMENT
MEASURE RUDDER CENTER
POSITION AND CONFIRM
DISPLAYED VALUE IS <5
°
.
IF NOT, ADJUST RRU ARM OR
MAGNET. NAVPILOT WILL
CORRECT REVERSED P & S
INDICATION LATER.
PUSH ANY KEY TO CONTINUE
NAVpilot-711/720
RRU SENSOR ALIGNMENT
ALIGNMENT TONE:
ON
20 10 5 5 10 20
20 10 5 5 10 20