.
Page 4
11/16/01
•
Option #2 – Furuno Network Cables With Ethernet Hubs
Example of NavNet Installation Using Furuno 6-Pin Female-to-Female Cables and
Furuno Hub Adapter Cables (6-Pin Male to RJ45 Male)
This cabling option allows Furuno NavNet Cables to be utilized for any NavNet when an
Ethernet 10BASE-T Hub is required for a multi-component NavNet system.
Use the same cables as listed in Table 3.1 for connection to each NavNet Component.
This option might be beneficial for certain installations because it provides a waterproof
Furuno cable up to the Ethernet RJ45 Hub connection.
Furuno Cable Selection Steps:
A. Select a proper length cable from Table 3.1(Page 3) for EACH NavNet Display or
Network Sounder.
Each cable must be routed to a suitable location where the Ethernet Hub will be
mounted.
Note: The Ethernet Hub Connection will not be completely weatherproof unless the hub
is installed in a weatherproof box. Please pay careful attention to the mounting location
and installation of the hub.
B. Utilize one “Furuno Hub Adapter Cable” for each NavNet Component.
A
Hub
Adapter Cable
is a 0.5 Meter Cable that will convert the 6 pin Furuno Plug to a Male RJ45
connector. This RJ45 connector will then plug directly into any 10BASE-T Hub.
000-144-463
Hub Adapter Cable 0.5m 6P(M)-RJ45(M)
6F
6F
6M
RJ-45M
6F
6F
6M
RJ-45M
6F
6F
6M
RJ-45M
Network
Sounder
6F
6F
6M
RJ-45M
Dealer Supplied
Ethernet Hub
Connect RJ45M Directly to Hub as Shown
Hub Adapter Cable P/N 000-144-463
