.
Page 24
11/16/01
AP- 1 – “QUICK SOFTWARE SETUP” – Basic Software
Settings For Single Display NavNet Configurations
Configuration #1 – One NavNet D BBFF1 + BBGPS
ATTENTION!
-Make Sure All Simulation Modes are set to “LIVE” – You should NOT see a small “SIM” box
anywhere on the display
-Don’t Change Any NETWORK SETUP or NETWORK SOUNDER SETUP settings in the
INSTALLATION SETUP menu – None are required for a single NavNet display system!
(STEP 1 is Required for Radar/Plotter Displays ONLY – FOR Plotter Displays, GO to STEP 2)
STEP 1 - Configure the Initial Radar Parameters in the Installation Mode
-Entering INSTALLATION MODE – With Display turned off, hold down MENU while pressing
Power momentarily to turn display on. Continue holding Menu Key for 10 Sec.
-Keystroke Sequence – MENU > SYSTEM CONFIGURATION > INSTALLATION SETUP > RADAR SETUP
– Configure EACH parameter in the list of initial radar settings. Note that some settings are
found by pressing the “Next Page” softkey – Refer to the Installation Manual for details.
-When finished configuring the radar settings, turn the display off, then on again to escape
from the INSTALLATION MODE.
STEP 2 – Change Nav Position Source to BBGPS –
-Keystroke Sequence #1 – Program DATA1 Port for BBGPS:
MENU > SYSTEM CONFIGURATION >SYSTEM SETUP > PORT SETUP > GPS/NMEA PORT – highlight
“Furuno GPS Sensor” > EDIT – highlight “YES” > ENTER > MENU – return to normal mode
-Keystroke Sequence #2 – Program Navigation Source for BBGPS:
MENU > SYSTEM CONFIGURATION > NAV OPTION > NAV SOURCE SETTINGS – highlight “Position
Source” > EDIT – Select “FURUNO BB GPS” > ENTER > MENU –
return to normal mode
STEP 3 – Configure Digital Depth and Temp Display for BBFF1
-Keystroke Sequence – MENU > SYSTEM CONFIGURATION > GENERAL SETUP – highlight
“TEMPERATURE SOURCE” > EDIT – select “ETR” > ENTER – Select “DEPTH SOURCE” > EDIT – select
“ETR” > ENTER > MENU – return to normal mode
Configuration #2 – NavNet D BBFF1 + Any GPS Source
Completely Remove
STEP 2
from the above procedure. Follow Step 1 and Step 3 to complete
the basic installation process.
NMEA/GPS Port and Position Source configuration is only required when the BBGPS is utilized.
Network
Cable
Any Plotter or Radar/Plotter
DATA1
Spd/Temp or Temp X-ducer
