5. ROUTINE MESSAGE CALLING, RECEVING
5-5
Unable acknowledge call received
1. Press the
CANCEL
key to silence the audio alarm. The pop-up message disappears.
The reason for UNABLE ACK is displayed on the receiving screen.
Reason for unable to acknowledge
•
NO REASON
•
CAN’T USE CH
•
BUSY
•
CAN’T USE MODE
•
EQUIP ERROR
•
CONGESTION AT CENTER*
•
QUEUE INDICATION*
•
OPERATOR ABSENT*
•
STATION BARRED*
•
TEMP. UNAVAILABLE*
*: Coast station use
2. If the coast station sends the message “QUEUE INDICATION,” wait until your turn
arrives.
3. Rotate the
ENTER
knob to select QUIT and then press the
ENTER
knob.
4. Rotate the
ENTER
knob to select CONTINUE and then press the
ENTER
knob.
If there are no responses from the coast station, do one of the following procedures:
•
Rotate the ENTER knob to select GO TO CALL and then press the ENTER knob to
re-send call.
•
Rotate the
ENTER
knob to select QUIT and then press the
ENTER
knob to cancel call.
5.1.2
Receiving an individual call
Unable acknowledge is sent automatically or manually depending on the REPLY TYPE
setting (see section 6.14). Able acknowledge is sent only manually.
Note:
The handset must be on hook to enable automatic acknowledge.
Sending unable acknowledge with REPLY TYPE “UNABLE”
When an individual call is received with “UNABLE” setting on REPLY TYPE menu, an
unable acknowledge is sent automatically. It takes about seven seconds to transmit the call.
Sending able/unable acknowledge manually with REPLY TYPE “ABLE”
When an individual call is received with “ABLE” setting on REPLY TYPE menu, the audio
alarm sounds and the pop-up message appears. Press the
CANCEL
key to silence the
audio alarm and close the pop-up message. There are three types of ACK transmission.
•
Sending able acknowledge call
1. Rotate the
ENTER
knob to select ACCEPT and then press the
ENTER
knob.
2. Rotate the
ENTER
knob to select GO TO CALL and then press the
ENTER
knob to
send able acknowledge call.
3. Communicate by radiotelephone or NBDP (see “Communicating by NBDP terminal unit”
on next page).
4. After you finish communicating, rotate the
ENTER
knob to select QUIT and then press
the
ENTER
knob.
5. Rotate the
ENTER
knob to select CONTINUE and then press the
ENTER
knob to finish
communication.
Summary of Contents for FS-2575
Page 1: ...SSB RADIOTELEPHONE FS 2575 FS 5075 OPERATOR S MANUAL www furuno co jp MODEL...
Page 14: ...SYSTEM CONFIGURATIONS xii This page is intentionally left blank...
Page 28: ...2 SSB RADIOTELEPHONE 2 8 This page is intentionally left blank...
Page 46: ...4 DISTRESS OPERATIONS 4 14 This page is intentionally left blank...
