Furuno FS-2575, Operator'S Manual

Page: 132 / 165

11. MAINTENANCE & TROUBLESHOOTING
11-4
11.4 Error Messages
The table below shows error messages, their meanings, and remedies. To delete the
messages, press the
CANCEL key. If other error occurs, contact your dealer.
Error message Meaning Remedy
ERROR:
TX PLL UNLOCK
[CANCEL]: Stop alarm TX PLL unlock. Transmission is
stopped.
Contact your dealer.
ERROR:
RX PLL UNLOCK
[CANCEL]: Stop alarm RX PLL unlock. Reception is
stopped.
Contact your dealer.
ERROR:
WR1(2) PLL UNLOCK
[CANCEL]: Stop alarm WR1(2) PLL unlock. Reception is
stopped.
Contact your dealer.
ERROR:
TUNE NG
[CANCEL]: Stop alarm Tuning failed. Transmission power
is decreased to LOW(2). For
NBDP, transmission is stopped. Try to tune again. If unsuccessful,
confirm if TUNE NG occurs on other
frequencies. See “Antenna coupler
cannot tune antenna” in section
11.3, or contact your dealer.
ERROR:
Tx power reduced.
Main AMP heated.
[CANCEL]: Stop alarm Power amplifier is too heated.
Transmission power is decreased
to one level lower.
ERROR:
Tx power reduced.
Natural TUNE
[CANCEL]: Stop alarm Tune error occurs. Transmission
power
is decreased to LOW(2) .
Try to tune again. If unsuccessful,
confirm if TUNE NG occurs on other
frequencies. See “Antenna coupler
cannot tune antenna” in section
11.3, or contact your dealer.
ERROR:
Tx power reduced.
Ship’s main failure.
[CANCEL]: Stop alarm
AC power is interrupted and DC
power is replaced with AC power.
Can use AC power with low
transmission power. Check AC
power and decrease the
transmission power to the minimum.
ERROR:
Communication error!
[CANCEL]: Stop alarm
Communication between the
transceiver unit and the control
unit is lost for a certain period.
Confirm if the transceiver unit and
the control unit are connected.
WARNING:
GNSS error
[CANCEL]: Stop alarm Sensor information from GNSS is
lost more than one minute.
Check the navigation equipment. If
the navigation equipment does not
work well, input the position
information manually.
WARNING:
Printer not ready
[CANCEL]: Stop alarm Automatic print is selected;
however, printer is not powered or
is disconnected. Check the printer.
WARNING:
Position data is not
updated!
Position was older than
XH.
Update it
[CANCEL]: Stop alarm Position data is older by the
amount of time preset on the
POSITION menu (see section 6.7). Reenter position on the POSITION
menu (see section 6.7).
System was rebooted. Unusual working is detected.
System restarts. Can use this equipment without
hitch.