Full Boar FBDDP-7500, Instruction Manual

Page: 18 / 28

18
ADJUSTMENTS (cont.)
Presetting the drilling depth
The drilling spindle has a swivelling scale ring for setting the drill depth. Only adjust the
setting when the machine is at a standstill. Make sure that the power plug is removed from
the socket-outlet before adjusting the setting.
To stop spindle (and bit) at a desired depth:-
1.
Loosen depth stop lock
knob (24) by turning in an
anti-clockwise direction (Fig.
28).
2. Rotate depth scale to the
desired depth, then
re-tighten knob (24)
(Fig. 29).
To hold the spindle (and bit) at a desired depth:-
1. Loosen depth stop lock knob (24), Turn feed handle (17) to
lowest point (Fig. 30)
2.
Rotate depth scale to desired depth and re-tighten depth
stop lock knob (24). This will hold assembly stationery at
desired depth.
Morse taper drill bits - MT2
To use Morse taper drill bits, remove chuck (16)
and arbor (33)
1. Move the drill chuck (16) to the lower position.
2. Lock the spindle (15) in the lowered position using the
depth scale to maximize access to the drill chuck (16)
3. Turn arbor (33) until the tang aligns with the slot in the
spindle (15) (Fig. 31).
1
Fig. 28
Fig. 29
Fig. 31
Fig. 30