Full Boar FBDDP-7500, Instruction Manual

Page: 13 / 28

13
ASSEMBLY (cont.)
IMPORTANT: Before you mount the drill chuck onto the spindle, check that both
parts are free of dirt and grease. This ensures optimal transmission of power.
Fig. 11
Fig. 13 Fig. 14 Fig. 15
13.
Force the arbor (33) into the top of the drill chuck (16) by
hand, using reasonable force (Fig. 11).
14.
The arbor (33) can then be inserted into the spindle (15),
twisting the arbor as you insert (Fig. 12). Guide it in until
it stops. Turn the chuck until it slips a little further into the
spindle. Now force the drill chuck upwards ( a firm tap on
the underside of the chuck with a soft face hammer can
be used) and check that it is secure.
15.
Assemble the rail (5) to the safety guard (8). Secure the
rail to the safety guard using the two screws (31) (Fig. 13).
16.
Push rail (5) into the safety guard bracket (6) (Fig. 14). Ensure the groove on the rail (5)
aligns with the groove in the safety guard bracket (6).
17.
Fit screw and washer (32) to rail (5) (Fig. 15).
IMPORTANT: The safety guard (8) is equipped with a microswitch. This prevents
the digital drill press from operating if the safety guard is open. To ensure that it
functions correctly, the safety guard (8) must be fitted in the “closed” position.
Fig. 12