Full Boar FBDDP-7500, Instruction Manual

Page: 17 / 28

17
ADJUSTMENTS (cont.)
1
Fig. 26
Fig. 27
1. Make sure that the power plug is removed from the
socket-outlet before changing bits.
WARNING! Only cylindrical bits with the stipulated
maximum shaft diameter may be clamped in the
drill chuck (9) (Fig. 26).
WARNING! Only use a bit that is sharp and free of defects. Do not use bits whose
shaft is damaged or which are deformed or flawed in any other way.
WARNING! Use only accessories and attachments that are specified in the
operating instructions or have been approved by the manufacturer. If the bench drill
should become jammed, switch off the machine and return the drill to its starting
position.
2. Your digital drill press is equipped with a keyless chuck.
This enables tools to be changed without the need for
an additional chuck key. To do so, insert the tool in the
drill chuck (16) and tighten by hand (Fig. 27).
1
WARNING! Do not open V-belt cover (22) when in use. Changing speed is
controlled by external speed control lever (2) and no access to the V-belt is required.
WARNING!
Always ensure the digital drill press is switched off and disconnected
from the power supply before installing/changing drill bits.
Installing straight shank drill bit