FULGOR OVFS9-10, Use & Care Manual, Page: 24 / 36

24
If the cook top is on, the key lock function locks all the sensors except the general on/off sensor and the
key lock. When the cook top is off, the key lock function locks all the sensors, including the general
on/off, except the key lock.
Unlocking the keypad
If the keypad is locked (the pilot light associated with the key lock sensor is on), holding down the key
lock
Sensor turns the key lock function off and the pilot light goes off.
Residual heat for radiant heaters
While a temperature on the cook top glass surface is above 65ºC, this condition will be shown in the
associated display, by means of an “H”.
If the cook top is switched off, the residual heat is shown by a static “H” in the display. If the cook top is
on, but the power level is 0, the associated display will show alternately “H” and “0”.
Operating the timer
The timer is activated by pressing the timer keys (+) or (-) up to the big central symbol . The timer
value can be selected between 1 and 99
minutes, and can be modified at any time.
To cancel the operation of the timer, select a timer value of <00> using the sensor (-), or switch off the
timer by
pressing the corresponding sensors (+) and (-) at the same time.
Heater on timer
This can be any of the touch-control heaters. When the timer value runs out, the heater associated with
the timer switches off.
The heater associated with the timer can be can be selected.
Selectable heater
The user can select the heater on which the timer function is to operate. The
selection of a new heater disables the previous selection in such a way that the timer only operates on
one heater each time.
The heater must always be selected before the time is set; otherwise, the timer will switch off.
If we take longer than 10 seconds to select the heater, the timer will switch off.
If, after selecting the heater, the time is not defined (T=00) in 10 sec., the timer switches off.
It is possible for the user to time a heater at power 0 .
If the configuration permits Alarm-mode , instead select a heater , the user touches again the timer in
the heater selection periode, it goes to minute-minder mode and at the end of time will not switch-off
any heater.
In Alarm-mode, the dot of the timer display doesn’t light.
Indication of the heater on timer with “t” on the heater display.
The touch control indicates the heater on which the timer is operating. This indication consists of a “t”
blinking with the power level in the display of the heater., 5sec every 15 sec. Also if the user changes
the value of the timer, the “t” blinks.
This option reminds the user at all times that the heater is on timer.
Indication of the heater on timer with Led (small symbol)
The touch control indicates the heater on which the timer is operating. This indication consists of a LED
(small symbol) next to the double display of the heater on timer.
This option reminds the user at all times that the heater is on timer.
Increasing the value of the timer
If the sensor (+) or (-) associated with the timer is held down, the value increases/decreases
automatically.