FULGOR OVFS9-10, Use & Care Manual, Page: 12 / 36

12
Setting the minimum for the oven thermostat
To set the minimum, proceed as follows:
Open the oven door;
Light the oven burner in the maximum position, close the door and wait for about 10
minutes (or the time required for the oven to heat up to about 230°C);
Remove the oven knob and, through the hole in the control panel, depending on the type
of thermostat (fìg. 8C), unscrew the by-pass screw of the thermostat by two turns;
Replace the knob and turn it to the minimum position , remove the knob and adjust the
previously loosened screws until a reduced, stable flame is acquired, even with rapid
changes from maximum and rapid opening/closing of the oven door.
N.B. For LPG, the setting for the oven burner minimum is obtained by screwing the
thermostat by-pass firmly down. Except in the case of 80 & 90 cm Fan forced gas
oven models, where the oven by-pass screw should be set to ¼ of a turn open.
When converting from Natural Gas to Universal LPG ensure that the NG regulator is removed and
replaced with the Test Point Assembly. When converting from Universal LPG to Natural Gas, fit the
Natural Gas regulator supplied with the conversion kit.
Figure 8
1.11. BEFORE LEAVING
Check all connections for gas leaks with soap and water. DO NOT use a naked flame for detecting
leaks. Ignite all burners to ensure correct operation of gas valves, burners and ignition. Turn gas taps
to low flame position and observe stability of the flame. When satisfied with the hotplate, please
instruct the user on the correct method of operation. In case the appliance fails to operate correctly
after all checks have been carried out, refer to the authorised service provider
2.5mm screwdriver