Fukuda Denshi FCP-7101, Service Manual

Page: 62 / 170

Chapter 3
3 - 28
●
Hardware inspections (10 items)
WARNING
If, during a hardware inspection, you notice damage or other abnormality,
immediately stop using the given unit; then replace the defective part,
replenish, or make proper repairs.
Failure to repair the unit can lead to a serious accident.
Do not replace the part nor carry out refilling or the like but change the
hardware (MAIN BOARD, for ex.) found faulty. If the trouble cannot be
remedied by replacing any part, for example, the guarantee clause of the
supplier will nopushply to the relevant hardware.
Checking the patient cable/connecting cable
Description
Check the patient cable/connecting cable for open circuit, the covered area
for damage, and the connector pins for interference/rust/contamination.
Checking the limb electrode/chest electrode
Description
Check for adherence of dust and rust.
Checking the recording paper/Keratin cream
Description
Check that they are set correctly.
Checking the operation manual
Description
Check that it is stored in the correct place without any damage.
Checking the trolley/cord hanger (if any)
Description
Check that trolley body's installation status, trolley's exterior, casters' status,
and cord hanger's exterior, and also check the mounting screws for
looseness.
Checking the enclosure
Description
Check the enclosure of the unit for flaws, cracks, deformation, rust, and
other exterior defects.
Checking the rating label
Description
Check the rating label for separation, cleanliness, legibility, and other
exterior defects.