Fujitsu SRS-1050, User Manual, Page: 32 / 140

SRS -1050 Voice Features ( Chapter 2
Page 2-4
•
If you want to place the call
from a Call Appearance other
than the one automatically
selected, press its CA button.
2. Dial the desired number by
pressing the keys on the
numeric keypad.
3. If your call is not answered, you
can hang up as follows:
a. Replace the handset in its
cradle.
or
b. Press another Call
Appearance button, which
will give you a dial tone
again. It will also either
hang up on the call you
made or automatically place
it on hold, depending on
your installation. Your
System Administrator can
tell you which occurs.
or
c. Press DROP.
4. If your call is answered,
converse with the called party.
5. When your conversation ends,
hang up by replacing the
handset in its cradle. Note the
displayed call duration; it
vanishes after about three
seconds.
Note: Onhook dialing . In place
of steps 1 and 2, you can dial
the number first and then pick
up the handset. The phone
automatically dials the
number. The number you
enter remains available for
dialing for about three
minutes.
You can also use a one-touch
button, which automatically
selects an idle CA and dials
the number. Steps 1 and 2 are
therefore unnecessary when
you use a one-touch button.
Once the call is dialed, you
can pick up the handset.
If you are already talking on
another call
1. Handle the active call in one of
the following ways:
a. End the call by pressing the
button in the handset cradle
to get a dial tone. (You can
also hang up the handset
and pick it up again.)
or
b. Retain the call by pressing
an idle Call Appearance
button to get a dial tone.
(The call is automatically put
on hold.)
or
continued