Fujitsu SPARC M10-4, Service Manual

Page: 258 / 514

Note -
Inactive/cold maintenance can be performed only for a building block configuration.
The inactive/cold maintenance procedure for a single-chassis configuration is the same as
that for stopping the system.
Caution -
Before you handle any components, wear a wrist strap to ground any static
electricity. If you perform this procedure without a wrist strap, individual
components or the overall system may be damaged. For details, see " 1.5 Notes
Regarding Static Electricity ."
12.3.3 Inactive/Hot maintenance
1.
Open the rack door.
2.
Confirm the hardware and software configurations.
For details, see " 4.2 Confirming the System Configuration ."
3.
Power off the physical partition requiring maintenance.
For details, see " 5.3 Powering Off the Physical Partition Requiring Maintenance ."
12.3.4 System-stopped maintenance
1.
Open the rack door.
2.
Confirm the hardware and software configurations.
For details, see " 4.2 Confirming the System Configuration ."
3.
Stop the entire system.
For details, see " 5.4 Stopping the Entire System ."
12.4 Removing an Internal Disk
This section describes the procedure for removing an internal disk. Perform
reduction using the same procedure.
Make the internal disk ready for removal before attempting to remove it. For details,
see " 12.3 Enabling the Removal of an Internal Disk ."
12.4.1 Accessing an internal disk
1.
Remove the front cover.
For details, see " 5.5.3 Removing the front cover ."
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
February 2014 234