Fujitsu SPARC M10-4, Service Manual

Page: 99 / 514

Note - When you incorporate a system board with the addboard command, the target system
board is incorporated into the physical partition after its hardware diagnosis. Therefore, it
may take time for the command execution to complete.
XSCF> addboard -c configure -p 0 01-0
PSB#01-0 will be configured into PPAR-ID 0. Continue?[y|n] :
y
Start connecting PSB to PPAR. [3600sec]
0..... 30..... 60..... 90.....120.....150.....180.....210.....240.....
270.....300.....330.....360.....390.....420.....450.....480.....510.....
540.....570.....600.....630.....660.....690.....720.....750.....780.....
810.....840.....870.....900.....930.....960.....end
Connected PSB to PPAR.
Start configuring PSB to Logical Domains (LDoms) Manager. [1800sec]
0.....end
Configured PSB to Logical Domains (LDoms) Manager.
Operation has completed.
Note - If you execute the addboard command without specifying the -m option or with
bind=resource specified for the -m option, the resource assignment state before deleteboard
command execution may not be restored.
If the pre-replacement amounts of system board resources such as CPUs and memory are
different from the post-replacement amounts, the resource assignment state cannot be
restored to the original state. If the resource assignment state is not restored to the original
state, the resources are placed in the free resource state. In this case, execute the ldm(1M)
command to assign the resources to the logical domain again.
XSCF>
showresult
0
XSCF>
showboards -a
PSB PPAR-ID(LSB) Assignment Pwr Conn Conf Test Fault
---- ------------ ----------- ---- ---- ---- ------- --------
00-0 00(00) Assigned y y y Passed Normal
01-0 00(01) Assigned y y y Passed Normal
In the following example, PSB 01-0 is incorporated into PPAR-ID 0.
3.
Execute the showresult command to check the end status of the addboard
command that was just executed.
The following example shows that "0" is returned as the end status and the
execution of the addboard command has been completed successfully.
4.
Execute the showboards command to confirm that the target chassis has
been incorporated into the physical partition.
The BB-ID of the chassis requiring maintenance is indicated by the system board
(PSB) number.
In the following example, [Fault] of PSB 01-0 displays "Normal", which indicates
that the system board is operating normally.
Chapter 6 Understanding the Preparations for Restoring the System 75