Fujitsu SPARC M10-4, Service Manual

Page: 189 / 514

XSCF> setdate -s 102016592013.00
Note - In the case of a dual power feed, connect the power cords in their original positions by
referring to the record that you made before the start of maintenance.
XSCF>
diagxbu -y -b 00 -t 01
yyyy.MM.DD-hh:mm:ss year.month.day-hour (24-hour clock):minute:second
MMDDhhmmyyyy.ss monthdayhour (24-hour clock) minuteyear.second
In the following example, "October 20, 2013 16:59:00" is specified.
11.
Start the entire system.
For details, see " 6.4.1 Starting the system with an XSCF command " or " 6.4.2
Starting the system from the operation panel ."
12.
Close the rack door.
When the system is configured with a hardware RAID
1.
Connect all the power cords to the PSU backplane unit of the chassis
requiring maintenance.
For details, see " 6.5.1 Installing the power cord ."
2.
Return to the operation of the XSCF firmware replacefru command to confirm
that the chassis has been incorporated into the system.
For details, see " 6.1.1 Incorporating an FRU of the SPARC M10-4/M10-4S into
the system ."
For a single-chassis configuration, you do not have to incorporate the chassis.
Proceed to step 4.
3.
Execute the diagxbu command to diagnose the crossbar cables.
Diagnosis is performed when the system board of the chassis connected with the
crossbar cables is not incorporated into the physical partition, or when the
physical partition into which the chassis is incorporated is powered off.
The example below specifies the following:
00: BB-ID of the chassis to start the diagnosis
01: BB-ID of the destination where the chassis to start the diagnosis is connected
(You can specify one or more of these.)
To specify multiple connection destination BB-IDs, enter a command like
"diagxbu -y -b 00 -t 01 -t 02".
4.
Execute the restoreconfig command to restore the XSCF setting information
only when the CPU memory unit lower in a singe-chassis configuration has
been replaced.
Chapter 7 Maintaining the CPU Memory Units 165