Fujitsu SPARC M10-4, Service Manual

Page: 87 / 514

XSCF>
poweroff -p 0
PPAR-IDs to power off:00
Continue? [y|n] :
y
00 : Powering off
XSCF>
showpparstatus -p 0
PPAR-ID PPAR Status
00 Powered Off
Note - Before stopping the system, inform the users that the system will be stopped.
Note -
When a physical partition is stopped by operating the XSCF command or the
operation panel, all the logical domains on the physical partition are stopped. Stop
applications as required.
8.
Execute the showpparstatus command to confirm that the power to the
physical partition is turned off.
In the following example, [PPAR Status] of PPAR-ID 00 displays "Powered Off",
which indicates that the power to the physical partition has been turned off.
9.
Switch the mode switches for the master chassis and those chassis whose
XSCFs are in the standby state to Service mode.
-
For a building block configuration (without crossbar box)
Switch the mode switches of BB-ID#00 and #01 to Service mode.
-
For a building block configuration (with crossbar box)
Switch the mode switches of BB-ID#80 and #81 to Service mode.
5.4 Stopping the Entire System
This section describes the procedure for stopping the entire system. To undertake
system-stopped maintenance, power off all the physical partitions to stop the entire
system before physically removing any components.
There are two ways of stopping the system, as follows:
■
Stopping the system with the XSCF command
■
Stopping the system from the operation panel
1.
Stop the entire system.
For details, see " 5.4.1 Stopping the system with the XSCF command " or " 5.4.2
Stopping the system from the operation panel ."
2.
Execute the showpparstatus command to confirm that the power to the
physical partition is turned off.
In the following example, [PPAR Status] of PPAR-IDs 00, 01, and 02 display
"Powered Off", which indicates that the power to all the physical partitions has
been turned off.
Chapter 5 Understanding the Preparations for Enabling Maintenance 63