Fujitsu PRIMERGY SX940, Manual

Page: 28 / 44

28 Review
SX940
ControllerLSI 1064 Different configurations
Verkabeln des Controllers 2
– Plug the controller into the contact strip of the main board #2 and fix it with
a screw (as mounting controller #1).
– Plug the connector HOST of the upper SAS cable into the SAS connector
(4) on the controller #2.
– Plug the connector P1 of the upper SAS cable into the connector on the HDD
diskbay 0/1 (5).
– Plug onto the connector P2 of the upper SAS cable a protective cap (see
figure on page 11) and lay the cable end at suitable location.
Figure 14: Position of the jumper: Four HDDs using two LSI 1064 controllers
I
Make sure that the jumpers on both HDD diskbays are in position 1-2.
1
2 2
3