84
The backup unit cannot be recognized from the server.
The drive SCSI ID setting is
correct?
No
No
No
No
Lit up green
What is the status of the Power LED?
No
No
No
No
Connect it properly.
"4.1 Connecting the SCSI Cable
for the Server" (p.75)
No
No
Refer to the following according to the
power switch setting.
- "Even when the power switch is set to
"|", the power cannot be turned on." (p.79)
- "Even when the power switch is set to "R",
the power cannot be turned on." (p.81)
The target backup unit is turned
on?
Deal with this problem referring to "The backup unit
cannot be turned on." (p.83)
The SCSI connector between
the I/O module and drive bay is
connected correctly?
The termination resistor is
connected correctly?
No
No
The SCSI cable between the I/O
module and drive bay is come
down?
The SCSI cable (for server
connection) is come down?
The SCSI cable (for server
connection) is connected correctly?
This product may fail.
Contact maintenance support.
Refer to each backup unit's manual for the setting,
and set it correctly.
(1) The server SCSI card is
recognized correctly?
(2) The Term Power setting is
correct?
Connect it properly.
"2. Installing Internal Options" (p.56)
No
No
(1) Refer to "Troubleshooting" in
the server or SCSI card's manual.
(2) Refer to each backup unit's manual
for the setting, and check that the
Term Power setting is correct.
Off
Lit up amber
Blinking green
Contact maintenance support.
Contact maintenance support.
Summary of Contents for PRIMERGY SX10 S2
