Fujitsu Primergy RX200 S4, User Manual

Page: 151 / 269

151
PRIMERGY RX200 S4 User's Guide
SATA model
—
: indicates that it cannot be installed.
Notes on installing expansion cards
Notes on individual cards
For information about specific expansion cards, see the manual supplied with the card and check the
notes. Also, check the following for various expansion cards.
Installing/Removing SCSI Ctrl U320 lp (PG-2281L)
Configuration information on the device changes by installing the SCSI Ctrl U320 lp (PG-2281L) in the
server because the bridge circuit is installed in the inside of the card.
Therefore, when adding/removing the SCSI Ctrl U320 (PG-2281) after OS installation, the onboard
LAN controller might be recognized by the OS as a new device.
Perform the onboard LAN settings (IP address etc.) and set software that uses the onboard LAN again
after adding/removing the card.
SAS RAID Ctrl cards
A battery backup unit (BBU) is provided with the SAS RAID Ctrl (PG-248C, PG-244C1, and PG-
248G1L). Make sure to install the battery backup unit.
"6.5.4 How to Install a Battery Backup Unit (BBU)" (p.156)
table: Installation location/order of expansion cards
Product name (Product ID)
PCI slot Maximum
number of
installed
cards
Installation
order
1 2
SAS RAID Ctrl (PG-244C1) —
1 1
1
2
1
SAS RAID Ctrl (PG-248G1L) 2
1
1 2
Fibre Channel Controller (PG-FC202) 1 2 1 3
SAS Ctrl (PG-228BL)
1 2
2
2
4
SCSI Ctrl U320 lp (PG-2281L) 1 2 2 5
Eth. Ctrl 2x1Gbit PCI-E 1000-BASE-T lp (PG-2861L) 1 2 2 6
Eth. Ctrl 1x1Gbit PCI-E 1000-BASE-T lp (PG-289L) 1 2 2 7
Eth. Ctrl 1x1Gbit PCI-E 1000BASE-SX lp (PG-288L) 1 2 2 8