Fujitsu Point 1600, Installation Manual

Page: 11 / 52

1-1
Chapter 1
Introduction to Connectivity Peripherals
Connectivity peripherals for the Point 510 and Point 1600 pen tablet systems are engineered using
modular design principles. Each connectivity peripheral is assembled using components which may be
used in different connectivity peripheral products. Components that make up connectivity peripherals
are shipped unassembled.
This chapter gives an introduction to each connectivity peripheral. Use this chapter to verify that the
components comprising the connectivity peripheral you intend to assemble are present. For details on
assembling these peripherals, refer to the appropriate section of Chapter 2.
Table 1-1 shows the model numbers for connectivity peripheral products. Note that some models are
available in locking and non-locking versions. The components used to assemble each connectivity
peripheral are described later in this chapter.
* The type of cradle module (locking or non-locking) installed in this assembly determines
whether the connectivity peripheral is a locking or non-locking version.
†
The cradle module is not sold as a separate product. It is sold as a component of other
connectivity peripherals.
Table 1-1. Connectivity Peripheral Model Numbers
Part Name
Locking/
Non-Locking
FPSI Model Number
Portable port expander N/A FMW26CR5
Port replicator
*
Locking FMW26CR3
Non-Locking
FMW26CR23
High-connectivity cradle
*
Locking FMW26CR2
Non-Locking FMW26CR22
High-usage cradle
*
Locking
FMW26CR1
Non-Locking FMW26CR21
Wall-mount cradle
*
Locking FMW26CR4
Non-Locking
FMW26CR24
Charge-only cradle N/A FMW26CR10
Cradle module
†
Locking FMW26CR8
Non-Locking
FMW26CR28